This is a Demo Server. Data inside this system is only for test purpose.
 

The effects of SiC particle addition on the foaming and mechanical behavior of aluminum closed-cell foams produced by foamming of powder compacts

dc.contributor.advisor Güden, Mustafa en
dc.contributor.author Yüksel, Sinan
dc.date.accessioned 2023-11-16T12:13:42Z
dc.date.available 2023-11-16T12:13:42Z
dc.date.issued 2010 en
dc.description Thesis (Doctoral)--Izmir Institute of Technology, Mechanical Engineering, Izmir, 2010 en
dc.description Includes bibliographical references (leaves: 144-153) en
dc.description Text in English; Abstract: Turkish and English en
dc.description xvi, 154 leaves en
dc.description.abstract The maximum and linear expansions of a large number of SiC particle/Al powder compacts of varying average SiC particle size (0.03-67 .m), weight percentage (wt%) and size distribution and Al compacts without particle addition were experimentally determined. The powder compacts showed varying expansion values depending on the size, wt% and size distribution of the particles. The linear and maximum expansions for small size SiC particle additions were found to be relatively high at relatively low wt%'s (5 wt%) and decreased with increasing wt% of the particles from 5 wt% to 10 and 15 wt%. The compacts with small average particle size but wider particle size distribution showed higher expansions than the compacts with the similar average particle size but narrower particle size distribution, showing the importance of the particle size distribution on the expansions of Al compacts. The foam expansions were further shown to increase with SiC particle addition until about a critical cumulative particle surface area; however, the expansions decreased significantly at increasingly high cumulative particle surface areas due to the excessive increase in the compact viscosity. For the investigated powder compacts, the optimum wt% of SiC addition was determined, as a function particle size, based on the critical cumulative particle surface area. Compression tests showed that the density of the foam was the most effective parameter in increasing the plateau stresses. Microscopic analysis showed that the main deformation mechanism in Al and SiC/Al foams was the cell wall bending, i.e. cell edges buckled over cell walls. This resembled the deformation characteristics of the open cell foams. It was finally shown that SiC particle addition increased the foam plateau stresses over those of Al foam without particle addition, which was mainly attributed to the reduced fraction of the metal on the cell edges. en
dc.identifier.uri http://standard-demo.gcris.com/handle/123456789/6348
dc.language.iso en en_US
dc.publisher Izmir Institute of Technology en
dc.rights info:eu-repo/semantics/openAccess en_US
dc.subject.lcsh Foamed materials en
dc.subject.lcsh Metal foams en
dc.subject.lcsh Aluminum foam en
dc.title The effects of SiC particle addition on the foaming and mechanical behavior of aluminum closed-cell foams produced by foamming of powder compacts en_US
dc.type Doctoral Thesis en_US
dspace.entity.type Publication
gdc.description.department Mechanical Engineering en_US
gdc.description.publicationcategory Tez en_US
gdc.oaire.accepatencedate 2010-01-01
gdc.oaire.diamondjournal false
gdc.oaire.impulse 0
gdc.oaire.influence 2.9837197E-9
gdc.oaire.influencealt 0
gdc.oaire.isgreen true
gdc.oaire.keywords Metalurji Mühendisliği
gdc.oaire.keywords Metallurgical Engineering
gdc.oaire.keywords Mechanical behavior
gdc.oaire.popularity 6.5821576E-10
gdc.oaire.popularityalt 0.0
gdc.oaire.publicfunded false

Files

Collections