This is a Demo Server. Data inside this system is only for test purpose.
 

The effects of SiC particle addition on the foaming and mechanical behavior of aluminum closed-cell foams produced by foamming of powder compacts

No Thumbnail Available

Date

2010

Journal Title

Journal ISSN

Volume Title

Publisher

Izmir Institute of Technology

Open Access Color

Green Open Access

Yes

OpenAIRE Downloads

OpenAIRE Views

Publicly Funded

No

Research Projects

Organizational Units

Journal Issue

Events

Abstract

The maximum and linear expansions of a large number of SiC particle/Al powder compacts of varying average SiC particle size (0.03-67 .m), weight percentage (wt%) and size distribution and Al compacts without particle addition were experimentally determined. The powder compacts showed varying expansion values depending on the size, wt% and size distribution of the particles. The linear and maximum expansions for small size SiC particle additions were found to be relatively high at relatively low wt%'s (5 wt%) and decreased with increasing wt% of the particles from 5 wt% to 10 and 15 wt%. The compacts with small average particle size but wider particle size distribution showed higher expansions than the compacts with the similar average particle size but narrower particle size distribution, showing the importance of the particle size distribution on the expansions of Al compacts. The foam expansions were further shown to increase with SiC particle addition until about a critical cumulative particle surface area; however, the expansions decreased significantly at increasingly high cumulative particle surface areas due to the excessive increase in the compact viscosity. For the investigated powder compacts, the optimum wt% of SiC addition was determined, as a function particle size, based on the critical cumulative particle surface area. Compression tests showed that the density of the foam was the most effective parameter in increasing the plateau stresses. Microscopic analysis showed that the main deformation mechanism in Al and SiC/Al foams was the cell wall bending, i.e. cell edges buckled over cell walls. This resembled the deformation characteristics of the open cell foams. It was finally shown that SiC particle addition increased the foam plateau stresses over those of Al foam without particle addition, which was mainly attributed to the reduced fraction of the metal on the cell edges.

Description

Thesis (Doctoral)--Izmir Institute of Technology, Mechanical Engineering, Izmir, 2010
Includes bibliographical references (leaves: 144-153)
Text in English; Abstract: Turkish and English
xvi, 154 leaves

Keywords

Metalurji Mühendisliği, Metallurgical Engineering, Mechanical behavior

Turkish CoHE Thesis Center URL

Fields of Science

Citation

WoS Q

Scopus Q

Source

Volume

Issue

Start Page

End Page

Collections

Google Scholar Logo
Google Scholar™

Sustainable Development Goals

SDG data could not be loaded because of an error. Please refresh the page or try again later.